• <dd id="affhv"><big id="affhv"></big></dd>
  • 
    
  • <dd id="affhv"></dd><li id="affhv"><acronym id="affhv"><u id="affhv"></u></acronym></li>
    <button id="affhv"><object id="affhv"><u id="affhv"></u></object></button>

  • <tbody id="affhv"></tbody>
    1. Hello! Welcome to Jiangsu Runtian Xincheng Intelligent Technology Co., Ltd!

      18912476492

      LOCATION:Home>>news>>Q&A>>What are the adjustment methods of cutting machine pressure

      Contact Us

      C

      Jiangsu Runtian Xincheng Intelligent Technology Co., Ltd

      Tell :0510-88991997

      Fax :0510-88991997

      Phone:18912476492

      E-mail:rtxcsales@rtxcnu.com

      Url      :www.rtxcnu.com

      Zip Code:214000

      Address:No. 81, Jinma Road, Hongshan Street, Xinwu District, Wuxi City


      Q&A
      分享至:

      What are the adjustment methods of cutting machine pressure

      DateTime:2020/05/16

      1, adjustable two claw block and gear disc orientation, the claw block upward movement, pressure increase shear claw block of each action of a tooth, the distance between the two surfaces change the amount of about 0.1 mm, usually adopt the action of only one tooth.


      2, when the claw block in the tooth plate bearing to the end of a tooth, you should consider a new gear and bias bias. The following methods can be used to adjust: loosen the screws to loosen the gear bias adjustment plate, and the gear wrench to adjust the back gear bias.


      Then note that the number of teeth should be rotated equally, no more than three teeth. Equipment tooth adjustment plate, screw, claw block will be adjusted to the first tooth, look for shear pressure effect, the effect is not satisfactory, you can make adjustments, should pay attention to the tooth of the rotation of the gear, should be smaller than the tooth of the first rotation.


      This method can also be used when the pressure on the left or right side is too low, that is, the small pressure adjusts which side and which side of the gear hurts, and tries to cut the claw block and return the 1-2 teeth properly.


      3. When the upper and lower pressure is applied, the release pad and the hook type fastening plate adjustment screw block and the gasket with the hook type pad to increase the thickness are used together to reduce the plate thickness in the cavity block, and the operating surface unit is used in the face of increasing pressure; Conversely, low pressure.

      contact us

      Tell :0510-88991997

      Fax :0510-88991997

      Phone:18912476492

      Phone:18661000660

      E-mail:rtxcsales@rtxcnu.com

      Url      :www.rtxcnu.com

      Zip Code:214000

      Address:No. 81, Jinma Road, Hongshan Street, Xinwu District, Wuxi City

      Copyright ? Jiangsu Runtian Xincheng Intelligent Technology Co., Ltd All rights reserved 蘇ICP備2020051884號-2
      毒龙钻是什么,空中飞人是什么服务,高山流水是什么服务项目,夜场小鸟归巢是什么服务_第1页